DTC 32

Fig. 123 Code 32: Right Rear Wheel Speed Sensor Frequency Error.:

DTC 32: Right Rear Wheel Speed Sensor Frequency Error:

TEST CONDITION(S)
1. Tested continuously.

FAILURE CONDITION(S)
1. While Driving: One wheel is detected at least 30 kph or 19 mph faster than the remaining wheels for an extended period of time.
OR
One wheel is at least 6 kph or 4 mph less than or greater than the remaining wheels for an extended period of time.

ACTION TAKEN
1. Code set.
2. ABS switched "OFF."
3. "ANTILOCK" indicator "ON."

TEST DESCRIPTION
Test numbers refer to circled numbers on the diagnostic chart.
1. Checks wiring and connections for problems. It is critical that this step is performed thoroughly, as wiring/connector problems are the most likely cause for this code.
2. Use the TECH 1 to monitor for vehicle electrical/electronic system "noise" being picked up by the speed sensor circuits.
3. Use the TECH 1 to monitor the wheel speed sensors while the vehicle is operating. If the TECH 1 Auto-Trigger Snapshot mode triggers, the speed sensor or the wiring and/or connectors are going intermittent during the road test.
4. Checks for proper resistance in the sensor itself.
5. Replace rear wheel speed sensor as the likely cause of the triggering intermittent.
6. Use the TECH 1 to monitor the wheel speed sensors while the vehicle is operating. If the TECH 1 Auto-Snapshot mode triggers, the EBTCM/EBCM must be concluding there is a problem with wheel speed sensor frequencies when there is not.
7. Checks for a short to ground in the speed sensor input circuit wires. The circuit to be tested depends on which speed sensor triggered the TECH 1. The ground may be either a "hard" short to ground, or a resistive short. A short with a resistance less that 2 megohms, though not a hard short, can still cause Code 32 to set.

DIAGNOSTIC AIDS
Be sure the speed sensor wiring is properly routed and retained. This will help prevent false signals due to electrical noise being picked up by the wiring.

It is very important that a thorough inspection of the wiring and connectors be performed. Failure to carefully and fully inspect wiring and connectors may result in misdiagnosis, causing part replacement with reappearance of the fault.