Water Pump and Balance Shaft Chain Tensioner Replacement

Water Pump and Balance Shaft Chain Tensioner Replacement

Removal Procedure

1. Remove the engine front cover. Refer to Engine Front Cover Replacement Service and Repair.





2. Remove the 2 tensioner bolts (2) and the water pump and balance shaft chain tensioner (1).

Installation Procedure

1. Reset the water pump and the balance shaft chain tensioner by performing the following steps:

1. Turn the tensioner plunger 90° in its bore and compress the plunger.

2. Turn the tensioner back to the original 12 o'clock position and insert a paper clip through the hole in the plunger body and into the hole in the tensioner plunger.

2. Clean the water pump and balance shaft chain tensioner sealing surface.





3. Install the water pump and the balance shaft chain tensioner (1).

Caution:
Refer to Fastener Caution Fastener Caution.

4. Install the 2 water pump and balance shaft chain tensioner bolts (2) and tighten the bolts to 10 Nm (89 lb in).





5. Remove the paper pin (1) from the tensioner (2).

6. Install the engine front cover. Refer to Engine Front Cover Replacement Service and Repair.