Engine Oil Dip Stick - Dip Stick Tube: Service and Repair

Oil Level Indicator Tube Replacement

Removal Procedure




1. Remove the oil level indicator tube bracket bolt (2).

2. Unclip the ECM wiring harness, the generator wiring harness and the vacuum tank hose from the oil level indicator tube brackets.

3. Remove the oil level indicator tube (1) from the oil pan.

4. Remove and DISCARD the oil level indicator tube seal ring (3).

Installation Procedure




1. Install the oil level indicator tube (1) to the oil pan along with a NEW seal ring (3).

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the oil level indicator tube bracket bolt (2) and tighten to 10 Nm (89 lb in).

3. Clip the ECM wiring harness, the generator wiring harness and the vacuum tank hose to the oil level indicator tube brackets.