Clutch Actuator Cylinder Pipe Replacement

Clutch Actuator Cylinder Pipe Replacement

Removal Procedure

1. Remove the transmission. Refer to Transmission Replacement Transmission Replacement.





2. Detach pressure line (1) from central release and unscrew bolt (2).





3. Remove connector for pressure line (1).

1. Remove retaining clip (2).

2. Remove connector.

Note:
If necessary, bend squeeze together slightly.

3. Replace retaining clip in connector.

4. Remove pressure line.

Note:
Carefully disengage retaining lugs.

1. Clip pressure line out of fastening sleeve using a screwdriver or equivalent.

2. Remove pressure line.





Note:
Fastening sleeve must be replaced after removal.

5. Remove fastening sleeve.

1. Disengage fastening sleeve (1) from clutch housing.

2. Slide fastening sleeve upwards.

3. Remove fastening sleeve.

6. Check seal ring and pressure line for damage, replace if necessary.

Installation Procedure





Note:
Insert projection on sleeve in the slot provided in the transmission.

1. Attach fastening sleeve (1). Push into transmission housing - must noticeably engage.





2. Install pressure line (1) and insert in fastening sleeve - must noticeably engage.

3. Attach pressure line and tighten nut (2).





4. Attach connector for pressure line (1) and put connector on pressure line - retaining clip (2) must noticeably engage.

5. Install the transmission. Refer to Transmission Replacement Transmission Replacement.