Transfer Case Fluid Replacement

Transfer Case Fluid Replacement

Removal Procedure

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.





Note: When performing the following procedure, use only hand tools to remove and install the drain and fill plugs.

Note: Ensure that an approved drain pan is used when draining the transfer case.

2. Remove and DISCARD the oil drain plug (1) and seal.





3. Remove and DISCARD the fill plug (1) and seal.
4. Allow the transfer case to drain completely.

Installation Procedure

Caution: Refer to Fastener Caution.





1. Install a NEW drain plug (1) and seal and tighten to 50 Nm (37 lb ft).
2. Fill the transfer case to the bottom of the fill plug hole with the recommended fluid.





3. Install a NEW fill plug (1) and seal and tighten to 50 Nm (37 lb ft).
4. Lower the vehicle.