Fuel Feed Pipe Replacement (LDK)

Fuel Feed Pipe Replacement (LDK)

Special Tools

* EN-796-A - Remover

* GE-611 - Torque Wrench

* GE-6600-207 - Installer

For equivalent regional tools, refer to Special Tools (Diagnostic Tools) Special Tools (Diagnostic Tools).

Removal Procedure

Warning

Relieve the fuel system pressure before servicing fuel system components in order to reduce the risk of fire and personal injury.

After relieving the system pressure, a small amount of fuel may be released when servicing the fuel lines or connections. In order to reduce the chance of personal injury, cover the regulator and the fuel line fittings with a shop towel before disconnecting. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

1. Relieve the fuel pressure. Refer to Fuel Pressure Relief Service and Repair.

2. Remove intake manifold cover. Refer to Intake Manifold Cover Replacement Intake Manifold Cover Replacement.





3. Remove the fastener (1) from the fuel pump module (2) with EN-796-A - remover.

4. Remove the fuel feed pipe plastic (3) with EN-796-A - remover from the fuel feed pipe metal (4).





5. Remove the 2 fasteners (1) and get out the fuel feed pipe metal (2).

Installation Procedure





Caution:
Refer to Fastener Caution Fastener Caution.

1. Install the 2 fasteners (1) to the intake manifold but do not tighten yet.

2. Install the fastener (2) to the fuel pump module and tighten to 30 Nm (22 lb ft)with GE-6600-207 - installer and GE-611 - wrench.

3. Tighten the 2 fasteners (1) to 7 Nm (62 lb in).

4. Install the fuel feed pipe plastic to the fuel feed pipe metal.