Front Bumper Fascia Replacement

Front Bumper Fascia Replacement












2.Remove the front wheelhouse liner front. Refer to Front Wheelhouse Front Liner Replacement Front Wheelhouse Front Liner Replacement .

1Front Bumper Fascia Fender Bolt (Qty: 2)
Caution:Refer to Fastener Caution .
Tighten 3 N �m (27 lb in)

2Front Bumper Fascia Fender Screw (Qty: 4)Tighten 3 N �m (27 lb in)

3Front Bumper Fascia Fender Push-In Retainer (Qty: 4)

4Front Bumper Fascia Fender Bolt (Qty: 2)Tighten 3 N �m (27 lb in)

5Lower Front Fascia Impact Bar Rear Bolt (Qty: 2)

Procedure
Loosen the lower front fascia impact bar rear bolts. Do not remove.
Tighten25 N �m (18 lb ft)

6Front Bumper Fascia

Procedure

1.Carefully push a small nylon wedge between the fascia and the guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the guide.

2.Disconnect the electrical connectors.

3.Transfer parts as needed.