Engine Oil Dip Stick - Dip Stick Tube: Service and Repair

Oil Level Indicator Tube Replacement (LF1)

Removal Procedure




1. Remove the oil level indicator tube bracket bolt (1).
2. Remove the oil level indicator and tube (2) by sliding the tube out from the lower crankcase hole.




3. Remove and discard the O-ring from the oil level indicator tube if damaged.

Installation Procedure




1. Install a NEW O-ring on the oil level indicator tube.




2. Install the oil level indicator and tube (2) by sliding the tube down through the lower crankcase hole.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the oil level indicator tube bracket bolt (1) and tighten to 10 Nm (89 lb in).