32 21 151 Replacing Left or Right Tie Rod

32 21 151 Replacing Left Or Right Track Rod End







NOTE: If the track rod end to track rod screw connection is released, it is necessary after reinstallation to carry out a chassis / wheel alignment check.







Release nut (1), if necessary, grip at inner Torx socket.
Tightening torque 32 21 2AZ.
Remove track rod end (2) from swivel bearing.

Installation note:
Keep track rod end to swivel bearing connection clean and free from oil and grease.
Replace self-locking nut.







Determine dimension (A) to simplify following adjustment of front axle.
Slacken bolt (1).
Tightening torque 32 21 3AZ.
Screw off track rod end; if necessary, grip track rod with open-end spanner.

Installation note:
Check gaiter for damage, replace if necessary.
Screw track rod end onto track rod to dimension (A).







After installation:
- Perform wheel alignment check