37 13 ... Removing and Installing/Replacing Pressure Lines (Front) For Oscillating Motor/Front Axle

37 13 ... - Removing and installing/replacing pressure lines (front) for oscillating motor/rear axle





Special tools required:





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!

Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.





Necessary preliminary tasks:
- Remove tank underride protection Removing and Installing/Replacing Left or Right Underbody Panelling
- Remove right underbody panelling Removing and Installing/Replacing Left or Right Underbody Panelling





Important!
Pressure line and connection on valve block must be fitted with suitable sealing plugs immediately after removal!





Release banjo bolts of pressure lines (1, 2) to front axle oscillating motor with special tool 37 1 151.

Release banjo bolts of pressure lines (3, 4) to rear axle oscillating motor with special tool 37 1 151.





Important!
When assembling, make sure that only the sealing plugs of the pressure line to be fitted are removed.

Do not damage sealing surfaces of pressure lines.

Note:
Make sure pressure lines are laid without tension and with sufficient spacing to adjoining components.





Installation sequence for pressure lines:

1. Install pressure lines (3, 4)
Tightening torque 37 14 14AZ 37 14 Electric Components.
2. Install pressure lines (1, 2)
Tightening torque 37 14 13AZ 37 14 Electric Components.





Installation Note:
Check seating and position of line holders (1), correct if necessary.





Release banjo bolts (1).

Seal pressure lines with suitable sealing plugs.

Installation Note:
Tightening torque 37 14 15AZ 37 14 Electric Components.





Open holder (1) and remove pressure lines.

Installation Note:
Replace damaged holder.





After installation:

- Fill and bleed hydraulic system 32 13 006 Bleeding Power Steering Unit
- Check pipe connections for leaks
- Carry out initial Dynamic Drive operation Initial Operation with Test Run of Dynamic Drive.