51 47 000 Removing and Installing/Replacing Front (Inside) Left or Right Entrance Cover Strip

51 47 000 Removing And Installing/Replacing Front (Inside) Left Or Right Entrance Cover Strip

Special tools required:







NOTE: To remove the footwell side trim from the A-pillar, it is only necessary to detach entrance cover strip in the front area. Preliminary tasks are not required.

Necessary preliminary tasks:
- Remove panel for door pillar
- Remove entrance cover strip at rear

NOTE: Front seat is shown removed for purposes of clarity.







Detach mucket (1) in area of entrance cover strip (2).
Unclip entrance cover strip (2) with special tool 00 9 317 starting at front.

Installation:
If necessary, replace faulty retainer (3).
If necessary, release clips (4) from vehicle.







Release entrance cover strip (1) at clips (2) and feed out.







Installation:
Lug (1) must not be damaged or missing; if necessary, replace entrance cover strip (3).
If necessary, replace faulty clips (2). Fit missing clips on entrance cover strip (3).
Fit entrance cover strip (3) with preinstalled clips (2).