51 16 200 Removing and Installing Storage Compartment

51 16 200 - Removing and installing storage compartment





Necessary preliminary tasks:
- Remove trim for storage compartment 51 16 212 Removing and Installing Trim for Storage Compartment
- Remove rear console 51 16 270 Removing and Installing/Replacing Rear Console





Lever out covers (1) and release screws underneath.
If necessary, detach cable from storage compartment.





Unscrew nuts (1).
Depending on equipment specification, disconnect plug connections (2).

Installation:
Ensure correct cable routing.





Pull off gaiter (1) towards top.
Detach plug connection (2) from holder and disconnect plug connection (2).





Raise storage compartment (2) at rear and feed out gaiter (1) through opening.
If necessary, disconnect further plug connections and feed out cable.
Remove storage compartment (2) towards rear/top.






Installation:
Guide (1) of storage compartment (2) must be fed behind panel (4) on left/right.
Version with ventilated multifunction storage:

Air duct (3) must be correctly inserted in storage compartment (2).