Removing and Installing/Replacing Side Trim Panel, Footwell, on A-pillar, Left

51 43 070 - Removing and installing/replacing side trim panel, footwell, on A-pillar, left





Necessary preliminary tasks:
- Remove front entrance cover strip (inside) 51 47 000 Removing and Installing/Replacing Front (Inside) Left or Right Entrance Cover Strip
- Remove trim panel for pedal assembly 51 45 185 Removing and Installing/Replacing Panel For Pedals.





Detach mucket (1) in area of side trim panel (2).
Release screw (3).
Remove hood/bonnet release lever (4) from side trim panel (2).





Release screw (1).
Unclip side trim panel (3) in direction of arrow from retaining points (2).
If necessary, disconnect associated plug connection and remove side trim panel (3).





Installation:
If necessary, lever out clips (1) remaining in bore.
If necessary, replace faulty clips (1).
Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.

Replacement:

Remove switch for unlocking rear lid Service and Repair.