Engine Oil Service

11 00 ... Engine Oil Service (N62/N62TU)

WARNING:
Risk of scalding.
Carry out work on the vehicle only when wearing oil- and heat-resistant protective gloves incl. forearm protection, face guard and protective apron.

IMPORTANT:
Carry out the engine oil service only when the engine is at operating temperature.
Observe the exact engine oil filling capacity.
Overfilling the engine with engine oil will result in engine damage.
Checking and drip-off times (at least 10 minutes) must be observed.

Recycling:
Catch and dispose of drained engine oil in a suitable collecting vessel.
Observe country-specific waste disposal regulations.

NOTE: Presentation: without underbody protection and reinforcement plate.

Unclip sensor opening on reinforcement plate.
Remove screw plug (1) from oil sump and drain engine oil.
Release screw plug (2) of oil filter cover (3).
Release oil filter cap (3).

Installation note:
Renew sealing ring (2) and wet with oil.
Check sealing ring (1) and renew, if installed.
Renew oil filter element (3) and slide into the oil filter cover.
Oil filter element (3) must snap audibly into place.

Insert oil filter element (3) into oil filter cover.

Installation note:
Oil filter element (3) must snap audibly into place.

Installation note:
Replace sealing ring.

Insert screw plug (1) for oil sump and tighten down.
Tightening torque 11 13 1AZ.
Install and tighten oil filter cover (3).
Tightening torque 11 42 2AZ.
Insert screw plug (2) of oil filter cover (3) and tighten.

Installation note:
Tightening torque 10 Nm

NOTE:
Pour in engine oil.
Start engine and run at idle until oil pressure indicator light goes out.
Switch off engine
Check oil filter cap and screw plugs (1 and 2) for oil filter cap and oil sump for leaks.
Assemble engine.

Checking engine oil level:
- Park vehicle on a horizontal surface
- Using the oil dipstick, check the engine oil level after five minutes on the engine at normal operating temperature
- Top up engine oil if necessary