Forward Looking Camera: Adjustments

66 54 001 Axially Adjusting Night Vision Camera







NOTE:
Mechanical setting - as described in the following - is only possible axially.
Vertical alignment can only be carried out with the BMW diagnosis system:
- Service functions
->Body
-> Night vision electronics
-> Calibration night vision electronics camera







NOTE: Installation location: Adjusting screw, Night Vision Camera F01,02,03:

Fold lid (1) in engine compartment lid gasket fixture mounting upwards as pictured.

NOTE: (2) = Installation location, adjusting screw, night vision camera







NOTE: Installation location: Adjusting screw, Night Vision Camera F07, F10,11,18, F12,13:

Fold up engine compartment lid seal (1) as shown.

NOTE: (2) = Installation location, adjusting screw, night vision camera







NOTE:
Front of vehicle must be parallel at distance (A) to headlight aiming device (1).
(A) = 2 m
Align a suitable straight object (2), e.g. a spirit level, horizontally on headlight aiming device.
Slowly carry out axial adjustment of night vision camera at adjusting screw (3).







NOTE: Image shows the CID picture in the vehicle.

If necessary, align the image of the night vision camera with aid of a second person.
Yellow help line (1) is displayed using diagnosis job.
Upper edge (2) must be aligned using adjusting screw parallel to yellow help line (1) in the CID.