Removing and Installing/Replacing Oil Sump Bottom Section (N62/N62TU)

11 13 020 - Removing and installing/replacing oil sump bottom section (N62/N62TU)





Necessary preliminary tasks:
- Remove reinforcement plate
- Remove oil drain plug and drain engine oil.





Unlock plug connection (1) on oil level sensor and disconnect.
Release screws and remove oil sump bottom section (2).
Tightening torque 11 13 2AZ .

Installation:
Clean sealing surfaces.
Replace seal.
Replace screws.

When replacing oil sump bottom section:

Convert oil level sensor.
Replace sealing ring.