11 61 362 Replacing Right Charge Air Duct

11 61 362 - Replacing right charge-air duct (N54)

Special tools required:
- 11 8 670 11 8 670 Pliers

Necessary preliminary tasks:
- Remove coolant expansion tank Service and Repair
- Remove underbody protection Removing and Installing/Replacing Front Underbody Protection (AWD)

Important!
Coat sealing rings of quick-connect couplings with antiseize agent.
Pressure pipes cannot be fitted without antiseize agent.

Mark vacuum hoses (1) and detach.
Unfasten bolts and nuts.
Tightening torque bolt 11 65 6AZ [1][2]Specifications.
Raise bracket (2) slightly.
Mark vacuum hoses on underside and detach.
Remove holder (2).

Release nuts and remove heat shield.

Release clamp and detach charge-air duct (1).

Installation:
Check O-rings and replace if necessary.
Prior to fitting, coat O-ring with suitable antiseize agent.

Unlock and detach coolant hose (1).
Unlock quick-connect coupling.
Detach charge-air duct (2) from intercooler (3) and remove.

Important!
Risk of damage! to sealing rings!
Special tool 11 8 670 11 8 670 Pliers is essential.

Attach charge-air duct (1) with special tool 11 8 670 11 8 670 Pliers to intercooler.

Installation:
- Coat sealing rings of quick-connect couplings with antiseize agent.
- Pressure pipes must audibly snap into place

Assemble engine.
Check DME (turbocharger) for correct operation.