51 11 156 Removing and Installing Front Bumper Trim

51 11 156 - Removing and installing front bumper trim





Necessary preliminary tasks:
Version with headlight washer system:
- Remove cover for headlight washer system 51 11 ... Removing and Installing/Replacing Cover For Headlight Cleaning System on Left on left/right





Release screws (1) on bumper trim (2).






Note:
The operation is described on the left side; proceed in the same way for the right side.

Release screws (1) on wheel arch trim (2).

Lift out wheel arch trim (2) at side.

Installation:
Make sure wheel arch trim (2) is in correct position.





Note:
The operation is described on the left side; proceed in the same way for the right side.

Press wheel arch cover (1) to one side.

Release screws (2).





Release screws (1) on bumper trim (2).






Important!
Do not damage bumper trim when pulling off.

Detach bumper trim (1) at sides.

Pull bumper trim (1) forwards slightly and if necessary disconnect plug connections on ultrasonic sensors and/or fog lights.
Remove bumper trim (1) towards front with aid of a 2nd person.

Installation:
Height adjustment, refer to Gap dimensions, body .