Removing and Installing (Replacing) Handbrake Lever

34 41 000 - Removing and installing (replacing) handbrake lever





Special tools required:
- 32 1 030 32 1 030 Lever





Necessary preliminary tasks:
- Remove storage compartment 51 16 200 Removing and Installing Storage Compartment





Lock adjuster unit (ASZE).
Actuate parking brake lever. Screw in special tool 32 1 030 32 1 030 Lever partially. Press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).





Release nuts (1) and remove carrier for center console (2).





Disconnect plug connection (1).
Release screws (2) and remove holder with DSC sensor.

Important!
Follow instructions on removing and installing DSC sensor Removing and Installing/Replacing DSC Sensor.





Unclip mounting clip (1) upwards out of balance arm (2).





Guide handbrake Bowden cables (1) with a screwdriver inwards and pull out of balance bar (2).





Disconnect cable (1) from handbrake check switch.
Release screw (2) and remove parking brake lever (3).

Installation:
Tightening torque 34 41 1AZ 34 41 Parking Brake.
Parking brake lever and adjustment unit (ASZE) are only exchanged completely as a single unit.





After installation:
- Adjusting parking brake Adjustments