Removing and Installing/Replacing Oil Sump Top Section (N62/N62TU)

11 13 010 - Removing and installing/replacing oil sump top section (N62/N62TU)





Special tools required:
- 17 0 030 17 0 030 Pliers











Release screw, remove tensioner (1) from A/C compressor drive belt (E65 only).





Release screws.





Release screws and remove oil sump top section.

Installation:
Replace sealing ring on dipstick guide tube.

Free sealing faces of seal debris and clean.

1. Replace gasket.
2. Install oil sump.
3. Insert all screws on transmission end,
4. Tighten down all screws on oil sump.
Tightening torque 11 13 2AZ [1][2]11 13 Oil Pan.