67 61 517 Replacing Drive With Gear (Rear) for Actuating Slide/Tilt Sunroof

67 61 517 - Replacing drive with gear (rear) for actuating slide/tilt sunroof





Necessary preliminary tasks:
- Remove rear grab handles 51 16 450 Removing and Installing/Replacing Rear Left/Right Grab Handle
- Remove trim for rear left and right roof pillar (C-pillar) Removing and Installing/Replacing Trim Panel for Rear Left or Right Roof Pillar
- Remove trim for rear left and right roof pillar (D-pillar) Pillar Trim
- Remove left and right interior lights Removing and Installing/Replacing Left or Right Interior Light (Side)
- Detach mucket in area of roofliner





Important!
Do not under any circumstance kink roofliner (1).

Unclip roofliner (1) at retaining point (2) towards bottom and lower.

Note:
Secure drive with gear for actuating slide/tilt sunroof (4) against falling out.

Release screws (3), tightening torque 54 13 1AZ 54 13 Electric Components (of Sun Roof).

Lower drive with gear for actuating slide/tilt sunroof (4).

Note:
Screws (3) are microencapsulated.

Unlock plug connection (5), disconnect and remove drive with gear for actuating slide/tilt sunroof (4).





Installation:
Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).





Installation:
- Initialize slide/tilt sunroof Testing and Inspection.