Replacing Rubber Mount for Transmission Mounting

22 32 001 - Replacing rubber mount for transmission mounting





Necessary preliminary tasks:
- Remove complete exhaust system Removing and Installing Complete Exhaust System
- Remove heat shield at rear.
- Remove heat shield at front
- Remove transmission underbody panelling
- Observe safety instructions 00 .. ... Lifting Vehicle With A Lifting Platform on raising the vehicle





Release crash pin.

Installation:
Tightening torque 22 32 1AZ 22 32 Transmission Mounts.
When fitting a new cross-member, the crash pin must also be replaced.
Screw head of crash pin must rest on transmission cross-member.





Unscrew nuts (2).
Release both rubber mount nuts on transmission.
Release screws (1) and remove transmission cross-member.