51 11 156 Removing and Installing Front Bumper Trim

51 11 156 - Removing and installing front bumper trim





Important!
Risk of mixing up
Different screws fitted.





Raise bonnet/hood.
Release screws (1) on bumper trim (2).





Note:
The operation is described on the left side; proceed in the same way for the right side.

Lever out trim (1 and 2) in direction of arrow.

Installation Note:
Make sure trims (2) are in correct installation position.





Installation Note:
Catches (1) on trim (2) must not be damaged.





Installation Note:
Catches (1) and guide (2) on trim (3) must not be damaged.





Release screws (1) on bumper trim (2).





Release screws (1) on wheel arch trim (2).





Important!
To avoid damage, unclip the bumper trim (1) in direction of travel.

Pull bumper trim (1) in direction of arrow off side guide.





Pull off bumper trim (1) towards front.
Version without headlight cleaning system:
If necessary, disconnect plug connections on fog lamps (2) and/or Park Distance Control (3).
Remove bumper trim (1) towards front (with aid of a 2nd person).





Version with headlight washer system:

Note:
Have a rubber plug on hand.
Unlock hose (1), detach and seal pump outlet (2).
Remove bumper trim towards front (with aid of a 2nd person).





Installation Note:
Tabs (1) on bumper trim (2) must not be damaged.