Replacing Radial Shaft Seal for Front Axle Output (ATC 300)

27 21 030 - Replacing radial shaft seal for front axle output (ATC 300)





Special tools required:
- 27 1 450





Important!
After completion of work, check transmission oil level Procedures.

Use only the approved gear oil in this transfer case.





Necessary preliminary tasks:
- Remove front propeller shaft.





Lever output flange (1) out of housing with screwdriver (2).

Lever radial shaft seal out of housing with a suitable tool.

Important!
Do not damage housing.





Drive in radial shaft seal with special tool 27 1 450.