51 46 006 - Removing and installing/replacing trim for rear parcel shelf

51 46 006 - Removing and installing/replacing trim for rear parcel shelf





Special tools required:
- 00 9 317 00 9 317 Trim Panel Wedge





Necessary preliminary tasks:
- Remove panel for roof pillar at front left/right Removing and Installing/Replacing Trim for Rear Left or Right Roof Pillar (Front)
Version without through-loading system:
- Remove backrest for rear seat Removing and Installing/Replacing Backrest for Rear Seat (Basic)
Version with through-loading system:
- Fold back backrest completely
- Remove left/right side section Removing and Installing/Replacing Left/Right Sides of Backrest on Rear Seat Backrest (Through-Loading) on rear seat backrest





Version with rear window roller blind only:
Release screws in luggage compartment.

Installation:
Tightening torque 51 46 3AZ [1][2]Rear Shelf.





Version with rear window roller blind only:
Disconnect plug connection (1).





Release center seatbelt finisher strip (1) and feed out seatbelt strap (3).
Release expander rivet and pull rear parcel shelf (4) forwards.
Feed out left/right seatbelt strap (2) and disconnect speaker plug connection.





Pull out rear parcel shelf (2) towards front.

Installation:
Slide rear window shelf (2) correctly into ventilation grill guides (1).





Installation:
Following parts of center seatbelt finisher strip (3) must not be damaged or missing:
1 - Guides
2 - Retaining lugs





Note:
The operation "Removing trim for rear parcel shelf" ends here.





If necessary, remove or replace rear window roller blind:
Lever out protective cap (1) on left/right with special tool 00 9 317 00 9 317 Trim Panel Wedge.

Installation:
Retaining lugs (2) of protective caps (1) must not be damaged or missing.





Lift out shelf (3) over rear groove (1) of rear window roller blind.
Pull front guide (2) out of shelf (3) and remove roller sun blind towards bottom.





Note:
The operation "Removing or replacing rear window roller blind" ends here.





Replacement only:
Remove left/right mid-range speaker (2) Removing and Installing/Replacing Rear Mid-Range Speaker (in Rear Shelf).
If necessary, remove left/right tweeter Removing and Installing/Replacing Rear Treble Speaker (in Rear Shelf).
Remove trims (1) for belt outlet on left/right from rear parcel shelf (3).