Replacing Rubber Mount for Transmission Mounting

22 31 001 - Replacing rubber mount for transmission mounting





Special tools required:
- 22 1 011
- 22 1 014 Tools and Equipment
- 22 1 016 Tools and Equipment
- 22 1 021 Tools and Equipment
- 33 3 144





Necessary preliminary tasks:
- Remove complete exhaust system Service and Repair (N52K only)
- If necessary, remove heat shield.
- Support transmission with hydraulic lifter.





Unfasten screws and remove transmission cross-member.
Tightening torque 27 00 10AZ [1][2]Mechanical Specifications.





Position special tool 22 1 016 Tools and Equipment on opening (2) and twist in screw (3) hand-tight against housing.
Pull out rubber mount with special tools 22 1 011 / 33 3 144 and nut (1).
Nut (1) = M 12x1.5 nut





Installation Note:
Arrow on rubber mount must point to arrow on housing.
Coat housing bore and rubber mount with Circolight, refer to BMW Parts Service.

Note:
Illustration similar





Insert special tool 22 1 014 Tools and Equipment with pins into openings of rubber mount.





Draw in rubber mount with special tools 22 1 014 Tools and Equipment / 22 1 021 Tools and Equipment / 33 3 144 and nut (1).
Nut (1) = M12x1.5