Removing and Installing/Replacing Rear Window

54 34 300 - Removing and installing/replacing rear window





Necessary preliminary tasks:
- Remove rear window module Removing and Installing/Replacing Rear Window Module
- Remove seal for rear window Removing and Installing/Replacing Seal For Rear Window





Unfasten screws.
Tightening torque 54 34 10AZ 54 34 Motor-Driven Convertible Top (Hydraulic Components).





Slacken screws on left and right.
Tightening torque 54 34 11AZ 54 34 Motor-Driven Convertible Top (Hydraulic Components).
Disconnect left and right plug connections (2).





Installation:
Adjust right grub screw to dimension A in relation to Hall sensor.
A = - 1 mm
Calibrating rear window:
Rear window must be moved downwards (signal from Hall sensor - rear window at bottom).
This enables the convertible top module to determine the starting travel of the rear window travel sensor.





Check function.

Warning!
Power window unit has no anti-trapping mechanism.