Replacing Both Rubber Mounts for Stabilizer Mounting

33 55 021 - Replacing both rubber mounts for stabilizer mounting





E61: If necessary, remove vibration damper from right retaining bracket of stabilizer.
Tightening torque 33 55 6AZ Rear Axle - Stabilizer Bar.
Release nuts (1) on both sides.
Tightening torque 33 55 3AZ Rear Axle - Stabilizer Bar.
Turn stabilizer in downwards direction.
Remove retaining bracket (2) on both sides.
Remove rubber mount (3) on both sides.

Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer if necessary clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.