Removing and Installing/Replacing Holder for Left or Right Push Rod/Stabilizer

31 35 007 - Removing and installing/replacing holder for left or right push rod/stabilizer





Remove front wheel Removing or Installing Front or Rear Wheel.
Remove stabilizer link Removing and Installing/Replacing Push Rod (Stabilizer Link) for Left/Right Stabilizer from holder (1).
Release screw (2).
Tightening torque 31 35 10AZ Front Axle - Stabilizer Bar.





Support swivel bearing with workshop jack and a suitable mounting.
Slacken nut (1).
Remove holder (2) for brake hose, pulse generator and if necessary brake pad sensor.
Remove screw (4) with holder (3) towards front.

Installation:
Replace self-locking nut.
Tightening torque 31 31 3AZ Spring Struts (Front).