51 11 156 Removing and Installing Front Bumper Trim

51 11 156 - Removing and installing front bumper trim (M6)





Important!
Risk of mixing up
Different screws fitted.





Raise bonnet/hood.
Release screws (1) on bumper trim (2).





Release screws (1) on bumper trim (2).





Note:
The operation is described on the left side; proceed in the same way for the right side.

Release screws (1) on wheel arch trim (2).





Important!
To avoid damage, unclip the bumper trim (1) in direction of travel.

Pull bumper trim (1) in direction of arrow off side guide.





Note:
Have a rubber plug on hand.

Pull bumper trim slightly towards front (with aid of a 2nd person).
Unlock hose (1), detach and seal pump outlet (2).





If necessary, disconnect plug connection (3) at cable for ultrasonic transducer.
Remove bumper trim (1) towards front (with aid of a 2nd person).





Installation Note:
Tabs (1) on bumper trim (2) must not be damaged.