Removing and Installing/Replacing All Rear Seat Belts

72 11 102 - Removing and installing/replacing all rear seat belts





Warning!
Read and comply with safety regulations [1][2]Safety Regulations for Handling Components with Gas Generators for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling may trigger the pyrotechnical seatbelt tensioner or side airbag and thereby cause injuries.

Switch off ignition!





Removing left and right seat belts:
Release screws (1) on left and right.
Unscrew nut (3).

Installation Note:
Guide lug of belt retractor must be seated in opening in body.

Tightening torques: 72 11 20AZ [1][2]Seat Belt Systems.
Key:
1. Retaining screw

2. Belt retractor

3. Securing nut

4. Belt retractor





Release screws (1) on left and right.
Tightening torque: 72 11 23AZ [1][2]Seat Belt Systems.
Disconnect plug connection (2).
Remove upper strap (3) on left and right.





Removing middle seat belt (except E67):
Release screws (1).
Tightening torque: 72 11 21AZ [1][2]Seat Belt Systems.
Remove lower straps (2) and center upper strap (3).





Installation Note:
Ensure correct installation sequence and installation position:
- Fittings of center lower strap/center upper strap must rest on stop (1).

- Secure lower strap on left and right through guides (2).