51 47 030 - Removing and installing/replacing entrance cover strip, rear (inside) left or right

51 47 030 - Removing and installing/replacing entrance cover strip, rear (inside) left or right





Special tools required:
- 00 9 321 00 9 310 Assembly Wedges (Set in Plastic Case)





Necessary preliminary tasks:
Version with rear seat (normal) only

- Remove rear seat Removing and Installing/Replacing Rear Seat.
Version with rear seat (comfort) only

- Move rear seat completely towards front and top.





Press entrance cover strip (1) at front towards bottom and feed out from door pillar trim (2).





Remove entrance cover strip (1) at front from clips (2) of door pillar.





Release plastic nut (1).

Feed cover strip (2) forwards and upwards out of trim (3) if necessary with aid of fishbone 00 9 321 00 9 310 Assembly Wedges (Set in Plastic Case) and remove.

If necessary, lever clips with end cutting pliers (head of pliers surface-ground) out of door pillar.

Note:
If necessary, detach mucket before removing trim on rear comfort seat.





Installation Note:
Feed in guide lugs (1) under trim (2).





Installation Note:
If necessary, replace faulty clips (1).

Clip mounts of entrance cover strip (2) must not be damaged.

Push clips (1) onto entrance cover strip (2).