Replacing Rubber Mount for Transmission Mounting

22 32 001 - Replacing rubber mount for transmission mounting





Necessary preliminary tasks:
- Remove rear underbody protection
- Remove complete exhaust system
- Remove exhaust system bracket (M47/N47)
- Support transmission with lifter.





If necessary, remove heat shield (1) on left and right.





Note:
N53 only

Release cable from holders (1).

Remove cable from holders on heat shield.

Note:
Illustration similar





M57/M57T2 only
Release screws (1) and nut (2) and remove transmission cross-member.
Remove rubber mount from transmission cross-member.
Tightening torque 22 32 3AZ/4AZ 22 32 Transmission Mounts.





M54/N52/N52K/N53/N62/N54 only:
Release screws (1) and nut (2) and remove transmission cross-member.
Remove rubber mount from transmission cross-member.
Tightening torque 22 32 3AZ/4AZ 22 32 Transmission Mounts.

Note:
On N62TU from 03/07, remove grounding strap from transmission support block.

Note:
Illustration similar.





(M47/N47)
Release screws and nut (1).
Remove cross member.
Tightening torque 22 32 3AZ/4AZ 22 32 Transmission Mounts.





(M47/N47)
Slacken nut (1).
Exchange rubber mount.
Tightening torque 22 32 3AZ 22 32 Transmission Mounts.