Removing and Installing/Replacing Vane Pump for Power Steering (M54)

32 41 060 - Removing and installing/replacing vane pump for power steering (M54)





Special tools required:
- 32 1 260 32 1 260 Pliers





Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.

Seal off pipe connections with plugs.





Necessary preliminary tasks:
- Draw off and dispose off hydraulic fluid from fluid reservoir
- Remove front underbody protection Removing and Installing/Replacing Front Underbody Protection





Remove Clic hose clamp (1) with special tool 32 1 260 32 1 260 Pliers.

Detach suction line (2) from vane pump (3).

Installation Note:
Make sure suction line is laid without tension and with sufficient spacing to adjoining components.





Release banjo bolt (1) and detach pressure line (2) from vane pump.

Installation Note:
Replace sealing ring.

Tightening torque 32 41 3AZ Pump and Oil Supply.





Remove pulley Removing and Installing/Replacing Belt Pulley on Vane Pump for Power Steering.

Remove deflection pulley from alternator.

Release screws (1).

Tightening torque 32 41 1AZ Pump and Oil Supply.

Remove vane pump (2) with holder through wheel arch.





After installation:

- Fill and bleed hydraulic system Service and Repair
- Check pipe connections for leaks