Replacing Rubber Mount for Transmission Mounting

22 31 001 - Replacing rubber mount for transmission mounting





Necessary preliminary tasks:
- Remove underbody protection
- Remove complete exhaust system Service and Repair
- If necessary, remove exhaust system bracket
- Support transmission with hydraulic lifter.





If necessary, remove heat shield (1) on left and right.





Note:
N53 only

Release cable from holders (1).

Remove cable from holders on heat shield.

Note:
Illustration similar





Release screws (1) and nuts (2) and remove transmission cross-member.
Remove transmission mount from transmission cross-member.
Tightening torque 23 71 2AZ/5AZ 23 71 Transmission Mounts.

Note:
Illustration similar.





(M47/N47)
Release screws and nut (1).
Remove cross member.
Tightening torque 23 71 2AZ/ 5AZ 23 71 Transmission Mounts.

Note:
Illustration similar





(M47/N47)
Slacken nut (1).
Exchange rubber mount.
Tightening torque 23 71 5AZ 23 71 Transmission Mounts.





M57/M57T2 only
Unfasten screws (1) and nuts (2).
Remove transmission cross-member.
Remove rubber mount from transmission cross-member.
Tightening torque 22 32 3AZ/ 4AZ 22 32 Transmission Mounts