Shift Linkage: Adjustments

Adjusting Shift Lever


- Move selector lever to "P" setting.




For cable clamping up to 8.95:
- Fit special tool 24 5 240 to the shift lever.

Note: Only possible to fit in "P" setting.

- Loosen nut (2).
- Press shift lever (3) forwards (park setting). Press cable (4) in direction of arrow, then release again.
- Tighten nut (2).
- Tightening torque: 10 Nm




Cable clamping from 8.95:
- Brace clamping section (1) and loosen nut (2).
- Press shift lever (3) forwards (park setting). Press cable (4) in direction of arrow, then release again.
- Brace clamping section (1) and tighten nut (2).
- Tightening torque: 10 Nm