Front Suspension

Stabilizer Bar

Special tools, testers and auxiliary items required

• Locating Pins (T10096)

• Engine/ Gearbox jack (V.A.G 1383 A)

• Torque Wrench 5-50 Nm (V.A.G 1331)

• Torque Wrench 40-200 Nm (V.A.G 1332)

Removing






- Remove the subframe. Refer to => [ Subframe ] Subframe.

- Remove the stabilizer bar from the subframe - 11 and 14 -.

- Remove the stabilizer bar.

Installing

Install in reverse order of removal. Note the following:

Tightening specifications, refer to => [ Subframe, Stabilizer Bar, Transverse Link, Ball Joint and Vehicle Level Sensor Overview ] Subframe, Stabilizer Bar, Transverse Link, Ball Joint and Vehicle Level Sensor Overview

Tightening specifications, refer to => [ Steering Gear Overview ] Steering Gear Overview

- Install the subframe. Refer to => [ Subframe ] Subframe.

- Replace locking element after each removal - item 11 - => [ (Item 11) Locking Element ] Subframe, Stabilizer Bar, Transverse Link, Ball Joint and Vehicle Level Sensor Overview.