Wheel Bearing Housing, Wheel Bearing Unit, Trailing Arm With Bracket and Stone Chip Protection Overview

Wheel Bearing Housing, Wheel Bearing Unit, Trailing Arm with Bracket and Stone Chip Protection Overview






1 - Expanding Rivet

2 - Stone Chip Protection

• Removing and Installing, refer to => [ Stone Guard ] Stone Guard

3 - Coupling Rod

4 - Bolt

• 90 Nm + 45° turn

• Always replace if removed.

5 - Trailing Link

• Removing and Installing, refer to => [ Trailing Arm with Mounting Bracket ] Trailing Arm With Mounting Bracket

• Longitudinal control arm, servicing => [ Trailing Arm Bonded Rubber Bushing ] Trailing Arm Bonded Rubber Bushing

6 - Bolt

• 8 Nm

7 - Wheel Speed Sensor

8 - Wheel Bearing Housing

• Removing and Installing, refer to => [ Wheel Bearing Housing ] Wheel Bearing Housing

9 - Bonded Rubber Bushing

• Replace => [ Wheel Bearing Housing Bonded Rubber Bushing ] Wheel Bearing Housing Bonded Rubber Bushing

10 - Nut

• 25 Nm

11 - Bonded Rubber Bushing

• Replace => [ Trailing Arm Bonded Rubber Bushing ] Trailing Arm Bonded Rubber Bushing

12 - Dust Cap

• Always replace if removed.

• Removing and Installing, refer to => [ Wheel Bearing Unit ] Wheel Bearing Unit

An appropriate seal can only be achieved with a new dust cap.

13 - Brake Rotor

14 - Bolt

• 4 Nm

15 - Bolt

• 200 Nm + 180° turn

• Always replace if removed.

• Before installing, clean the threads in the wheel bearing housing with a tap.

• Loosen and tighten with the socket M18 multi-point socket (T10162)

• wheel hub threaded connection to stub axle, loosening and tightening (same procedure as on a vehicle with AWD), refer to => [ Hex Bolt Between Drive Axle and Wheel Hub, Loosening and Tightening ] Hex Bolt Between Drive Axle and Wheel Hub, Loosening and Tightening

16 - Wheel Bearing Unit

• The ABS sensor ring is installed in the wheel bearing unit

• Removing and Installing, refer to => [ Wheel Bearing Unit ] Wheel Bearing Unit

• The wheel bearing unit is maintenance-free and has zero play. Adjusting or servicing is not possible!

17 - Bolt

• 10 Nm

18 - Cover Plate

19 - Bolt

• 50 Nm + 45° turn

• Always replace if removed.

20 - Bolt

• 90 Nm + 90° turn

• Always replace if removed.

21 - Bracket