Three-Point Seat Belt With Belt Tensioner/Force Limiter

Three-Point Seat Belt with Belt Tensioner/Force Limiter

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Follow all regulations when disposing of pyrotechnic components. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, Storage, Transporting and Disposal ] Airbag, Belt Tensioner and Battery Cut-Out Units, Storage, Transporting and Disposal.

- Switch off the ignition.

- Disconnect battery ground cable.

- Remove the front outer belt end fitting. Refer to => [ Front Outer Belt End Fitting ] Front Outer Belt End Fitting.

- Remove side trim. Refer to => [ Rear Side Trim ] Rear Side Trim.

- Remove subwoofer (optional equipment) on left side.

- Remove belt relay anchorage point - 1 -.






- Thread belt webbing - 3 - out of bracket - 2 -.

• Before handling pyrotechnical components (for example, when disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Release electrical connector - 7 - on belt tensioner with a screwdriver - 8 -.

- Disconnect electrical connector on belt tensioner.

Vehicles with a Switchable Force Limiter (country-specific)






- Release electrical connector - 6 - on belt load limiter with a screwdriver - 8 -.

- Disconnect electrical connector on belt load limiter.

Procedure for all Vehicles

- Remove bolt - 5 -.

- Remove three-point seat belt - 4 - from mount.

Installation

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling belt tensioners (for example, when connecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

• Make sure the connectors are installed all the way in and are secure.

Install in reverse order of removal. Note the following:

- Insert belt tensioner with anti-twist mechanism - arrow 1 - in mount - arrow 2 -.






- After installing the passenger side three-point seat belt, check the child seat belt function (country-specific). Refer to => [ Child Seat Anchorage, Checking Function ] Child Seat Anchorage, Checking Function.

- Connect battery ground cable with ignition switched on.

For the correct tightening specifications; refer to => [ Front Three-Point Seat Belt Assembly Overview ] Front Three-Point Seat Belt Assembly Overview.