Leak Detection Pump: Service and Repair

Leak Detection Pump (LDP) (V144)

Removing

- Remove rear left wheel housing liner.

- Disconnect the bleed line - 2 - from the diagnosis pump and disengage it from the bracket - arrow -.






- Disconnect electrical connector - 3 -.

- Disconnect vent line - 5 - by pressing release button.

- Remove nuts - 1 and 4 -.

- Disengage diagnostic pump with bracket.

Installing

• Tightening specification, refer to => [ EVAP Canister and Leak Detection System Overview ] EVAP Canister and Leak Detection System Overview.

Installation is carried out in the reverse order while noting the following:

• Vent line - 5 - must engage audibly.

- Install left rear wheel housing liner.