Accelerator Pedal Module, Version 1

Accelerator Pedal Module, Version 1

Special tools, testers and auxiliary items required

• Release Tool (T10238)

Removing

- Remove cover for steering column - arrows -.






- Disconnect electrical harness connector - 2 -, by pressing release button to the stop - arrow -.






- Where necessary, pull the wiring router - 1 - off from the accelerator pedal module.

- Pry off the cover using a screwdriver.

- Remove the bolt.

- Push the (T10238) into the intended openings - arrow - as far as the stop, as shown, and remove the accelerator pedal module.






Installing

• Tightening specification, refer to => [ Accelerator Pedal Module Overview, Version 1 ] Accelerator Pedal Module Overview, Version 1.

Install in reverse order, paying attention to the following:

- Connect the wiring router - 1 - and the electrical connector - 2 - to the accelerator pedal module - 5 -.






• The connector must engage audibly.

- Push the accelerator pedal module onto the securing studs - 6 -.

- Insert centering pin - 7 - into hole on the underbody.

- Secure the accelerator pedal module with the bolt - 3 - and install the cap - 4 -.

Vehicles with Dual Clutch Transmission:

- Perform after the first kick-down adaptation in "Guided Functions"using the vehicle diagnostic tester.