Floor Covering

Floor Covering

Removing

- Remove the left and right front seats. Refer to => [ Front Seat ] Front Seat.

- Remove the rear bench seat. Refer to => [ Bench Seat ] Bench Seat.

- Remove driver side instrument panel cover. Refer to => [ Driver Side Instrument Panel Cover ] Driver Side Instrument Panel Cover.

- Completely remove center console. Refer to => [ Rear Center Console ] Rear Center Console.

- Remove accelerator pedal module.

- Remove the push knobs - 1 - and remove the cover for the steering column universal joint.






- Remove the lower trim on the left and right A-pillars. Refer to => [ Lower A-Pillar Trim ] Lower A-pillar Trim.

- Remove left and right sill panel strip. Refer to => [ Sill Panel Trim ] Sill Panel Trim.

- Remove the footrest cover. Refer to => [ Foot Rest Cover ] Foot Rest Cover.

- Remove the front outer belt end fitting. Refer to => [ Front Outer Belt End Fitting ] Front Outer Belt End Fitting.

- Remove the expanding clips - 2 - (quantity: 8).






- Detach the carpet from the brackets - 1 -.

- Detach the carpet from the omega clips - 3 -.

- Disengage wiring harness - 4 - and - 5 - from retainers.

- Pull the carpet - 6 - toward the rear.

• Make sure the floor covering does not tear at the openings.

- Fold the carpet lengthwise, guide under wiring harness - 4 - and - 5 - and remove through a door.

Installation

Install in reverse order of removal. Note the following:

- Fold the new floor mat lengthwise and place in vehicle.

- Slide the carpet all the way forward until it matches up with holes for the accelerator pedal, the foot rest and the cover for the steering column universal joint.

- Attach the carpet to the brackets - 1 - and too the omega clamps - 3 -.






- Install the expanding clips - 2 - (quantity: 8).