Ignition Coil: Service and Repair

Ignition Coils with Power Output Stages

Special tools, testers and auxiliary items required

• Ignition Coil Puller (T40039)

Removing

- Remove engine cover.

- Open both bolts on the connector strip.

- Pull all the ignition coils out approximately 30 mm from the spark plug holes using the (T40039).






The following step applies only to the engine code CETA.

- Disconnect the connectors - 5 through 12 - on the all cam adjustment actuators.






- Release the connectors and pull all connectors simultaneously off from the ignition coils.






Installing

- Insert all ignition coils loosely into each spark plug shaft.

- Align the ignition coils to the connectors and then connect all of the connectors simultaneously onto the ignition coils.

- Press the ignition coils uniformly onto the spark plugs by hand (do not use any impact tools).