Coolant Pump Drive Shaft Seal

Coolant Pump Drive Shaft Seal

Special tools, testers and auxiliary items required

• Thrust Piece (T10353)

Procedure






- Remove small coolant pipe. Refer to => [ Small Coolant Pipe ] Small Coolant Pipe.

- Remove the coolant pump toothed belt. Refer to => [ Coolant Pump Toothed Belt ] Coolant Pump Toothed Belt.

- Firmly press a screwdriver - 1 - on the seal surface - 2 - - arrow B -.

- Pry out the seal - arrow A -.

- Clean the running and sealing surface.

- Coat the sealing surface of the balance shaft - 2 - with transmission oil.






- Push the seal - 1 - onto the balance shaft.

• "Luftseite" or ("Outside") - arrow - must be readable from the outside.

- Mount the (T10353) on the shaft seal - 1 - and then tighten it all the way into the cylinder block with the screw - 2 -. Be careful not to tilt the shaft seal when doing this.






- Install the coolant pump toothed belt. Refer to => [ Coolant Pump Toothed Belt ] Coolant Pump Toothed Belt.

- Install after-run coolant pump (V51). Refer to => [ After-Run Coolant Pump (V51) ] After-Run Coolant Pump (V51).

- Install the small coolant pipe. Refer to => [ Small Coolant Pipe ] Small Coolant Pipe.

- Fill the coolant system. Refer to => [ Filling: ] Service and Repair.