Engine Oil Cooler

Engine Oil Cooler

Special tools, testers and auxiliary items required

• Drip tray for VAS 6100 (VAS 6208)

Removing

Risk of scalding due to hot steam and hot coolant.

• The coolant system is under pressure when the engine is warm.

• Cover the coolant reservoir cap with a cloth and then open it slowly to release the pressure in the system.

- Drain the coolant. Refer to => [ Coolant, Draining and Filling ] Service and Repair.

- Remove the accessory assembly bracket. Refer to => [ Accessory Assembly Bracket ] Service and Repair.

- Remove the bolts - 4 and 5 - and remove the engine oil cooler - 3 - together with the seal - 2 -.






Installing

Installation is carried out in the reverse order while noting the following:

• For the correct tightening specifications, refer to => [ Oil Filter and Oil Cooler Overview ] Service and Repair.

• Always replace gaskets and seals.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Electronic Parts Catalog (ETKA).

- Install the engine oil cooler - 3 - with a new seal - 2 -.






- Install the accessory assembly bracket. Refer to => [ Accessory Assembly Bracket ] Service and Repair.

- Replace coolant. Refer to => [ Filling: ] Service and Repair.