Fan Shroud: Service and Repair

Fan Shroud

Removing

• If there are small impressions on the fins. Refer to => [ Coolers, Condensers and Charge Air Coolers ] Coolers, Condensers and Charge Air Coolers.

- Remove the bolts - arrows - and air guide.






- Remove both the lower air guide and the air guide hose.

- Remove the noise insulation.

- Remove the frame for the noise insulation.

- Remove the air guide hose - 1 and 2 -.






- Remove the bolt - 1 - from below.






• Ignore items - 2, 3 and 4 and the arrow -.

- Disconnect the connector - 2 -.






- Remove the bolts - 3 -.

- Disconnect the electrical connectors - arrow - and free up the electrical wire.






- Loosen the hose clamp - 2 - from above.

- Remove the bolt - 4 - and the air guide pipe.

• Ignore - 1 and 3 -.

- Remove the bolts - 1 - from above and the fan shroud.






Installing

• For the correct tightening specifications, refer to => [ Radiator, Fan Shroud and Coolant Fan Overview ] Radiator, Fan Shroud and Coolant Fan Overview.

Installation is carried out in the reverse order while noting the following:

- Air guides, installing with connector. Refer to => [ Air Guide Pipes and Hoses with Connector Coupling ] Service and Repair

• The hose supports, air guide pipes and hoses must be free of oil and grease before installing.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Electronic Parts Catalog (ETKA).

• To mount the charge hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.