Washer Fluid Reservoir

Washer Fluid Reservoir

Special tools, testers and auxiliary items required

• Drip tray

Removing

- Switch off the ignition and remove the ignition key.

- Remove the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Remove the left front wheel.

- Remove the left front wheel housing liner..

- Place a drip tray under the washer fluid reservoir.






- Remove the hose coupling - 1 - from the headlamp washer system fluid line - 3 - by pulling the release button.

- Cut through the cable ties - 2 and 4 -.

- Remove the plastic wedge - 5 -.

- Disconnect the electrical connectors - 7 and 8 -.






- Release the securing clip and remove the washer fluid line - 9 - from the windshield washer system washer fluid pump.

- Loosen the wiring harness - 2 - from the mounts on the washer fluid reservoir.

- Remove the screws - 1 and 3 -.

- Pull the washer fluid reservoir forward slightly and out.

- Disconnect the electrical connector - 5 -.

- Loosen the headlamp washer system fluid hose - 6 - and wiring harness - 4 - from the mounts on the washer fluid reservoir.

- Remove the washer fluid reservoir.

Installing






• Tightening specifications and sequence. Refer to => [ Washer Fluid Reservoir, Tightening Specification and Sequence ] Removal and Replacement.

- When inserting the washer fluid reservoir, make sure the securing tab - 1 - engages in the mount - 2 - on the fender.

Install in reverse order of removal, observing the following:

- Install left front wheel house liner..

- Install the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.