Rear Side Window, Adjusting

Rear Side Window, Adjusting

Special tools, testers and auxiliary items required

• Hex Ball Socket (T10058)

• Use to adjust the height

• Side Window Installation Tool (V.A.G 1739)

• Use to adjust laterally.

• Gauge (T10391)

Lateral Adjustment

• Adjustment dimensions, gap dimensions, refer to => [ Rear Side Window, Adjustment and Gap Dimensions ] Rear Side Window, Adjustment and Gap Dimensions.






A - Adjusting - the Top of the Side Window

• For positioning the upper edge of the side window - 4 - to the seal on the convertible top.

• Accessible after removing the rear side trim panel..

- To adjust, remove the nuts and screws on the side window mount. Refer to => [ Side Window Mount ] Side Window Mount.

- Loosen the lock nut - 1 - and turn the adjusting pin - 2 - with a TORX socket.

• Turn to the left - the side window rotates outward

• Turn to the right - the side window rotates inward

- Tighten the lock nut after adjusting - 1 -. For the tightening specification, refer to=> [ Window Regulator Motor and Window Regulator Overview ] Window Regulator Motor and Window Regulator Overview.

- 3 - Window regulator

B - Adjusting - Side Window, Bottom Edge

• For positioning the upper edge of the side window - 4 - to the seal on the convertible top.

• Accessible after removing the rear side trim panel..

- To adjust, remove the nuts and screws on the side window mount. Refer to => [ Side Window Mount ] Side Window Mount.

- Loosen the lock nut - 1 - and turn the adjusting pin - 2 - with a TORX socket.

• Turn to the left - the side window rotates toward the inside

• Turn to the right - the side window rotates toward the outside

- Tighten the lock nut after adjusting - 1 -. For the tightening specification, refer to=> [ Window Regulator Motor and Window Regulator Overview ] Window Regulator Motor and Window Regulator Overview.

- 3 - Window regulator

C - Adjusting - Front Edge Of The Side Window

• For positioning the side window - 4 - to the front door window.

• Accessible after removing the rear side trim panel..

- To adjust, remove the nuts and screws on the side window mount. Refer to => [ Side Window Mount ] Side Window Mount.

- Loosen the lock nut - 1 - and turn the adjusting pin - 2 - with a TORX socket.

• Turn left - the door window rotates inward

• Turn right - the door window rotates outward

- Tighten the lock nut after adjusting - 1 -. For the tightening specification, refer to=> [ Window Regulator Motor and Window Regulator Overview ] Window Regulator Motor and Window Regulator Overview.

- 3 - Window regulator

Height Adjustment

• Adjustment dimensions, gap dimensions, refer to => [ Rear Side Window, Adjustment and Gap Dimensions ] Rear Side Window, Adjustment and Gap Dimensions.






- Adjusting - Side Window

• For positioning the upper edge of the side window - 2 - to the seal on the convertible top.

• Accessible after removing the rear side trim panel..

- Loosen the nuts - 1 - and adjust the side window.