Center Differential Housing Overview, Bolted Driveshaft

Center Differential Housing Overview, Bolted Driveshaft

• => [ Repair Information ] Repair Information.

• => [ Clean Working Conditions ] Clean Working Conditions.

The center differential housing can also be removed and installed with the transmission installed. Refer to => [ Center Differential Housing and Center Differential, Bolted Driveshaft ] Center Differential Housing and Center Differential, Bolted Driveshaft.






1 Bolt

• Aluminum bolts

• Quantity: 11

• Replace

2 Housing

• For the center differential

3 Ball Bearing

• For the flange shaft

• Removing and installing, refer to => [ Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing ] Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing

4 Spacer Sleeve

• Removing and installing, refer to => [ Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing ] Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing

5 Gear Carrier

• Installed position: The tab must fit into the opening in the transmission intermediate housing

6 Spacer Sleeve

7 Adjusting Ring

8 Ball Bearing

• For the center differential

9 Center Differential

10 Ball Bearing

• For the center differential

11 Pressure Spring

12 Adjusting Ring

13 Plate Spring

• Installed position: The side curved outward faces the shaft seal - 17 -

14 Locking Ring

• For the flange shaft

• Removing and installing, refer to => [ Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing ] Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing.

15 Bolt

• Steel bolts

• Quantity: 2

• Replace


16 Balance Weight

• Installed depending on the version

17 Shaft Seal

• Removing and installing, refer to => [ Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing ] Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing

18 Rear Flange Shaft

• Without vibration damper

• For the correct allocation, refer to the Parts Catalog

• Removing and installing, refer to => [ Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing ] Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing

19 Rear Flange Shaft

• With vibration damper

• For the correct allocation, refer to the Parts Catalog

• Removing and installing, refer to => [ Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing ] Rear Flange Shaft And Rear Flange Shaft Seal And Ball Bearing

20 Bolt

• 20 Nm + 90° turn

• Replace

Tightening Specification and Sequence, Center Differential Housing - Bolted Driveshaft





- Tighten bolts in 8 stages as follows: