Center Differential Housing Overview, Attached Driveshaft

Center Differential Housing Overview, Attached Driveshaft

• => [ Repair Information ] Repair Information

• => [ Clean Working Conditions ] Clean Working Conditions.

The center differential housing can also be removed and installed with the transmission installed. Refer to => [ Center Differential Housing and Center Differential, Bolted Driveshaft ] Center Differential Housing and Center Differential, Bolted Driveshaft.






1 Bolt

• 20 Nm + 90°

• Replace

2 Bolt

• Aluminum bolts

• Quantity: 11

• Replace

3 Housing

• For the center differential

• Removing and installing, refer to => [ Center Differential Housing and Center Differential, Bolted Driveshaft ] Center Differential Housing and Center Differential, Bolted Driveshaft or => [ Center Differential Housing and Center Differential, Attached Driveshaft ] Center Differential Housing and Center Differential, Attached Driveshaft

4 Gear Carrier

• Installed position: The tab must fit into the opening in the transmission intermediate housing

5 Center Differential

6 Pressure Spring

7 Guide Sleeve

• Does not have to be installed again

8 Locking Ring

• For the transmission output shaft ball bearing with splines

• Removing and installing, refer to => [ Transmission Output Shaft with Splines, Transmission Output Shaft Ball Bearing with Spines ] Transmission Output Shaft With Splines, Transmission Output Shaft Ball Bearing With Spines.

9 Locking Ring

• For the transmission output shaft with splines

• Removing and installing, refer to => [ Transmission Output Shaft with Splines, Transmission Output Shaft Ball Bearing with Spines ] Transmission Output Shaft With Splines, Transmission Output Shaft Ball Bearing With Spines.

10 Ball Bearing

• For the transmission output shaft with splines

• Removing and installing, refer to => [ Transmission Output Shaft with Splines, Transmission Output Shaft Ball Bearing with Spines ] Transmission Output Shaft With Splines, Transmission Output Shaft Ball Bearing With Spines

11 Bolt

• Steel bolts

• Quantity: 2

• Replace

12 Balance Weight

• Installed depending on the version

13 Shaft Seal

• Replace on vehicles with vibration damper, refer to => [ Transmission Output Shaft with Splines, Transmission Output Shaft Ball Bearing with Spines ] Transmission Output Shaft With Splines, Transmission Output Shaft Ball Bearing With Spines

• Replace on vehicles without vibration damper, refer to => [ Transmission Output Shaft with Splines, Vehicles without Vibration Damper ] Transmission Output Shaft With Splines, Vehicles Without Vibration Damper

14 Dust Ring

• Replace after removing

15 Transmission Output Shaft with Splines Without Vibration Damper

• For the correct allocation, refer to the Parts Catalog

• Removing and installing, refer to => [ Transmission Output Shaft with Splines, Transmission Output Shaft Ball Bearing with Spines ] Transmission Output Shaft With Splines, Transmission Output Shaft Ball Bearing With Spines

16 Transmission Output Shaft with Splines and Vibration Damper

• For the correct allocation, refer to the Parts Catalog

• Removing and installing, refer to => [ Transmission Output Shaft with Splines, Transmission Output Shaft Ball Bearing with Spines ] Transmission Output Shaft With Splines, Transmission Output Shaft Ball Bearing With Spines

• => [ Vibration Damper, Installing on Transmission Output Shaft with Splines ] Vibration Damper, Installing On Transmission Output Shaft With Splines

Tightening Specification and Sequence, Center Differential Housing - Attached Driveshaft





- Tighten bolts in 8 stages as follows: